![]() ![]() Sleeve labelers are faster than other labeler types, able to label up to 200 containers a minute. A short sleeve dropped over the container neck becomes a tamper-evident seal. The label conforms to the shape of the container after passing through a heat tunnel. Sleeve Labelers drop a heat-shrinkable plastic sleeve label over a container. Accutek pressure-sensitive labelers range from economical tabletop models up to high-speed rotary labelers. Pressure-sensitive Labelers can apply a single wrap-around label to the front, back, and neck of a bottle, as well as the top and bottom of a container, or separate labels to the front, rear, and neck of a container. Soup and paint cans are often labeled this way. Hot Melt Glue Labelers apply thin stripes of molten glue to the back of a paper label that is then wrapped around the container. Accutek offers three different labeling systems, all of which use cutting-edge technology to achieve the highest speed and accuracy in the labeling machine market. Our products comply with the IATA requirements for the transport of diagnostic specimens (UN packing instruction 602 and 650), assuming that our products are properly used (closed).Accutek makes a variety of labeling machine equipment that can automatically place and secure most label types on a variety of containers. Upon request, Micronic products can be supplied gamma irradiated or ethylene oxide treated. ![]() Micronic labware products are developed and manufactured in compliance with the European Directive 98/79/EC for In Vitro Diagnostic Medical Devices, Annex III. Products produced by Micronic are tested according to AQL inspection level G2 and AQL value 0.4. The 2D Data-Matrix code (which adheres to the ECC200 standard) and 1D barcode (type 128B) are laser-etched into the code area and are guaranteed unique. The Micronic 2D Data-Matrix codes and 1D barcodes are produced conform industry standards. Our products are periodically tested on RNase, DNase and their endotoxin levels by independent expert organizations. RNase, DNase and endotoxin (pyrogen)īy maintaining the highest possible hygiene level during our production processes, Micronic manufactured labware is free of any detectable RNase or DNase contamination and the endotoxin level of produced and packaged labware is limited to an acceptable minimum (< 0.01 EU/ml). One selection criteria is that no measurable amount of extractables should leach into samples. The materials used for Micronic tubes are the result of extensive research. Material components used to produce Micronic labware can be traced via the lot number indicated on the packaging. The materials are FDA approved and comply with the (USA) USP XXII tests, including class VI (Medical approved), and the European Pharmacopoeia-monograph 3.2.2 unless communicated otherwise. The raw materials and auxiliary agents are selected based on the specifications that satisfy the high quality requirements of our products. Virgin material and approvalsįor the manufacturing of its long term sample storage labware products Micronic uses solely virgin plastic raw material. ![]() Micronic labware is manufactured and assembled in-house in a NEN-EN-ISO14644-1 Class 7 certified clean room environment (which is comparable to the US Federal Standard 209E Class 10,000). The environmental policy of Micronic is determined by our headquarters in the Netherlands, which is certified to ISO 14001:2015. Reducing our impact on the environment is an integral part of our continuous improvement efforts. Micronic operates corporate integrated Quality Management System (QMS) that is certified to ISO 9001:2015. Our Standards Product Quality Information
0 Comments
Leave a Reply. |